PROPRIETARY AND CONFIDENTIAL DRAFT 5 Feb 04
4 - 11
NOTE:
Ensure the thick end of the wall mount
plate is facing the top of the modified post.
4. Install two #10-32 x 3/8” screws in the
upper holes of the modified post.
NOTE:
Do not tighten the screws.
5. Slowly lower the warmer head assembly into the
modified post.
NOTE:
Ensure the slots on the bottom of the warmer head brackets
line up with the modified post.
6. Tighten the upper screws, and install and tighten the
remaining two #10-32 x 3/8”screws in the lower holes.
7. Thread the warmer power cable out through the
controller opening and connect it to J4.
8. Mount the controller and the back cover on the
modified post.
To Next Page
Loading...
