EasyManuals Logo

Dragino LSN50 User Manual

Dragino LSN50
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
www.dragino.com
LSN50 LoRa Sensor Node User Manual 24 / 60
The above photos shows the two parts of the magnetic switch fitted to a door.
The software by default uses the falling edge on the signal line as an interrupt. We need to
modify it to accept both the rising edge (0v --> VCC , door close) and the falling edge (VCC -->
0v , door open) as the interrupt.
The command is:
AT+INTMOD=1 //(more info about INMOD please refer AT Command Manual. )
Below shows some screen captures in TTN:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dragino LSN50 and is the answer not in the manual?

Dragino LSN50 Specifications

General IconGeneral
BrandDragino
ModelLSN50
CategoryAccessories
LanguageEnglish

Related product manuals