To Next PageTo Next Page
Need help?Do you have a question about the Dragino LHT65 and is the answer not in the manual?
General| Brand | Dragino |
|---|---|
| Model | LHT65 |
| Category | Accessories |
| Language | English |
Provides an overview of the Dragino LHT65 sensor's capabilities and purpose.
Lists the key features and specifications of the LHT65 sensor.
Details the technical specifications of the built-in and external sensors.
Describes the idle and transmit power consumption of the device.
Specifies the acceptable temperature ranges for device operation and storage.
Outlines the various use cases and industries for the LHT65 sensor.
Explains the two operating modes (Deep Sleep and Working Mode) and activation methods.
Describes the default LoRaWAN Class A mode and network joining process.
Provides a step-by-step guide to connect the LHT65 to the TTN network.
Explains the structure and components of the sensor's uplink data payload.
Guides on integrating LHT65 data with the myDevices platform.
Introduces data logging and details its functions like Unix timestamps and polling.
Describes the alarm mode feature for temperature alerts.
Explains the function of the triple color LED for status indication.
Configures the interval for sending data uplinks.
Sets the operating mode for connected external sensors.
Controls the transmission of the DS18B20 probe ID.
Sets or retrieves the device password for AT command access.
Exits AT command mode, requiring password re-entry.
Puts the device into a low-power sleep mode.
Sets the device's internal system time using Unix format.
Configures time synchronization via LoRaWAN MAC commands.
Defines the interval for synchronizing the device's system time.
Retrieves stored data entries from flash memory by page.
Retrieves the most recent data entries from flash memory.
Clears all stored data from the device's flash memory.
Describes the un-rechargeable Li-MnO2 battery used in the LHT65.
Provides instructions on how to replace the device's battery.
Links to a report for detailed analysis of device power consumption.
Details the specifications and connection of the E1 temperature probe.
Describes the E2 extension cable and its pinout.
Outlines the specifications of the E3 flat temperature probe.
Details the specifications of the E5 illumination probe.
Explains how to connect and use AT commands for device configuration.
Guides on the process of updating the LHT65 firmware.
Instructions for changing the device's LoRa frequency and region settings.
Steps to configure the LHT65 for use with single-channel gateways.
Provides instructions on how to reset the LHT65 device.
Links to information on the device's frequency plans.
Explains why the payload might appear as 00 in certain conditions.
Troubleshoots issues with entering AT commands.
Explains the cause of the 327.67°C temperature reading.
Addresses issues where the device does not respond.
Provides guidance for registration issues on specific frequency bands.
