Dragino LHT65 - Set LHT65 Time Sync Interval; Print LHT65 Data Entries by Page

www.dragino.com
LHT65 Temperature & Humidity sensor 37 / 56
Command Example
Function
AT+SYNCMOD=1
Enable Sync system time via LoRaWAN MAC Command
(DeviceTimeReq)
Downlink Command:
0x28 01 // Same As AT+SYNCMOD=1
0x28 00 // Same As AT+SYNCMOD=0
3.9 Set Time Sync Interval
Feature: Define System time sync interval. SYNCTDC default value: 10 days.
AT Command:
Command Example
Function
AT+SYNCTDC=0x0A
Set SYNCTDC to 10 (0x0A), so the sync time is 10 days.
Downlink Command:
0x29 0A // Same as AT+SYNCTDC=0x0A
3.10 Print data entries base on page.
Feature: Print the sector data from start page to stop page (max is 400 pages).
AT Command: AT+PDTA
Command Example
Response
AT+PDTA=1,3
Print page 1 to 3
8019500 19/6/26 16:48 1 2992 sht_temp=28.21 sht_hum=71.5 ds_temp=27.31
8019510 19/6/26 16:53 1 2994 sht_temp=27.64 sht_hum=69.3 ds_temp=26.93
8019520 19/6/26 16:58 1 2996 sht_temp=28.39 sht_hum=72.0 ds_temp=27.06
8019530 19/6/26 17:03 1 2996 sht_temp=27.97 sht_hum=70.4 ds_temp=27.12
8019540 19/6/26 17:08 1 2996 sht_temp=27.80 sht_hum=72.9 ds_temp=27.06
8019550 19/6/26 17:13 1 2998 sht_temp=27.30 sht_hum=72.4 ds_temp=26.68
8019560 19/6/26 17:22 1 2992 sht_temp=26.27 sht_hum=62.3 ds_temp=26.56
8019570
8019580
8019590
80195A0
80195B0
80195C0
80195D0