EasyManuals Logo

Dragino LSN50 User Manual

Dragino LSN50
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
www.dragino.com
LSN50 LoRa Sensor Node User Manual 36 / 60
remove the D1 and shortcut the two pads of it so there won’t be voltage drop between
battery and main board.
3. Using the AT Commands
3.1 Access AT Commands
LSN50 supports AT Command set in the stock firmware. You can use a USB to TTL adapter to
connect to LSN50 for using AT command, as below.
In the PC, you need to set the serial baud rate to 9600 to access the serial console for LSN50.
LSN50 will output system info once power on as below:

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dragino LSN50 and is the answer not in the manual?

Dragino LSN50 Specifications

General IconGeneral
BrandDragino
ModelLSN50
CategoryAccessories
LanguageEnglish

Related product manuals