36
As shown in the image above, there are 4 steps to upload settings files
to the instrument. Each step is highlighted in GREEN as you progress
through the process:
1) File Selection – Click the BROWSE button to path to the
configuration file to upload. Select the file and click Open.
2) Upload – Click the UPLOAD button to transfer the configuration
file to the instrument.
3) Update – Click the UPDATE button to save the configuration
information into the instrument.
4) Complete – When Complete is highlighted, uploading the
configuration has been succesfully completed.
Real-Time Measurements
Select Data > Meters to view the real-time metering information.
Real-time measurements are updated about every 5 seconds. The table
as follows lists the real-time parameters displayed and their units.
To Next Page
Loading...