- 19 -
TROUBLESHOOTING
WARNING
FOR YOUR OWN SAFETY, TURN SWITCH OFF
AND REMOVE PLUG FROM THE POWER SUPPLY
PROBLEM PROBABLE CAUSE REMEDY SUGGESTED
Blades Breaking 1. Wrong tension 1. Adjust blade tension
2. Over working blade 2. Reduce feed rate
3. Wrong blade application 3. Use narrow blades for cutting
tighter curves, wide blades for
more open curves and straight cuts.
4. Twisting blade 4. Avoid side pressure on blade
5. Incorrect blade setting 5. Check setting as per manual
Motor will not run 1. Defective cable,plug or fuse 1. Replace defective parts
2. Defective motor 2. Consult your service agent. Any
attempt to repair this motor may
be dangerous unless the repair
is carried out by a qualified
service agent.
Vibration 1. Increase mounting of saw 1. Refer to the mounting
NOTE: There will always be some instructions in this manual
vibration when the saw is running
due to the motor operation 2. Unsuitable mounting 2. The heavier your work bench is
surface the less vibration. A plywood
workbench is not as good as
solid timber.
3. Loose table 3. Tighten table locking knob
4. Loose motor mounting 4. Tighten mounting screws
Blade runout - 1. Blade guides not aligned 1. Check blade guide settings as per
manual
IMPORTANT
Please note all repairs/service should be carried out
by a qualified person.
DRAPER TOOLS HELPLINE:
(023) 8049 4344
To Next Page
Loading...
