- 15 -
MAINTENANCE
CHANGING TYRES
Eventually the rubber tyres on the bandsaw wheels will wear due to the constant contact of
the sharp teeth of the blade. Remove the blade, lift the edge of the tyre with a small
screwdriver and the tyre can be worked off the wheel easily.We recommend that the three
tyres be changed at the same time. (See Spare Parts Listing/Drawing). Refit blade
BLADE GUIDES
Blade guides should be inspected regularly for wear or chipping.When replacing guides
replace all guides at the same time, both upper and lower. (See Spare Parts Listing/Drawing).
BEARINGS
All bearings used in the construction of your bandsaw and its motor are sealed and
lubricated for life.
CLEAN OUT
Accumulated dust and chips should be removed from inside the bandsaw frequently.
Disconnect from the power supply, remove the front cover and use a brush or vacuum
cleaner. At the end of every work session clean sawdust away from the motor vents.
BLADE BRUSH
Ensure that you check on a regular basis that the brush is in full contact with the bandsaw
blade and wheel.This will help to keep the tyres on the wheel clean and assist with the quick
and smooth run down of the bandsaw blade.
NOTE: Bandsaw blade should stop within 10 seconds of the machine being switched off as
per original set up.
OPTIONAL ACCESSORIES
Stock No. Part No. Blade width Teeth Blade length Application Quantity
25766 BB1785 1/4" 6 skip 1785mm wood/plastic 1 pack
25767 BB1785 3/8" 6 skip 1785mm wood/plastic 1 pack
25768 BB1785 1/2" 6 skip 1785mm wood/plastic 1 pack
25769 BB1785 1/4" 6 skip 1785mm metal 1 pack
25770 BB1785 1/2" 6 skip 1785mm wood/metal 1 pack
Stock No. Part No. Grade Quantity
25971 SD6 60 5 pack
25972 SD6 80 5 pack
25973 SD6 100 5 pack
25974 SD6 120 5 pack
25975 SD6 *Assorted 5 pack
*1x60, 2x80, 1x100, 1x120
Stock No. Part No. Grade Quantity
25988 SB1785 60, 80, 120 3 pack
Bandsaw Blades
Sanding Discs
Sanding Belt
To Next Page
Loading...
