Vigor2955 User’s Guide
42
3
3
.
.
2
2
.
.
4
4
V
V
L
L
A
A
N
N
PCs connected to Ethernet ports of the router can be divided into different groups and
formed VLAN. PCs under the same groups can share each other information through the
router and will not be peeked by other groups.
The LAN >> VALN allows you to configure VLAN settings through wired connection to
achieve the above intention. Simply check P1 and P2 boxes on the line of VLAN0; and
check P3 and P4 boxes on the line of VLAN1.
Enable Check this box to enable this function (for VLAN
Configuration).
P1 – P4 Check the box to make the computer connecting to the port
being grouped in specified VLAN. Be aware that each port
can be grouped in different VLAN at the same time only if
you check the box. For example, if you check the boxes of
VLAN0-P1 and VLAN1-P1, you can make P1 to be grouped
under VLAN0 and VLAN1 simultaneously.
VLAN0-3 This router allows you to set 4 groups of virtual LAN.
3
3
.
.
2
2
.
.
5
5
B
B
i
i
n
n
d
d
I
I
P
P
t
t
o
o
M
M
A
A
C
C
This function is used to bind the IP and MAC address in LAN to have a strengthen control in
network. When this function is enabled, all the assigned IP and MAC address binding
together cannot be changed. If you modified the binding IP or MAC address, it might cause
you not access into the Internet.
Click LAN and click Bind IP to MAC to open the setup page.
To Next Page
Loading...
Need help?
General
