Vigor2955 User’s Guide
56
2. UDP flood attack
3. ICMP flood attack
4. Port Scan attack
5. IP options
6. Land attack
7. Smurf attack
8. Trace route
10. Fraggle attack
11. TCP flag scan
12. Tear drop attack
13. Ping of Death attack
14. ICMP fragment
15. Unknown protocol
Below shows the menu items for Firewall.
3
3
.
.
4
4
.
.
2
2
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
General Setup allows you to adjust settings of IP Filter and common options. Here you can
enable or disable the Call Filter or Data Filter. Under some circumstance, your filter set can
be linked to work in a serial manner. So here you assign the Start Filter Set only. Also you
can configure the Log Flag settings, Apply IP filter to VPN incoming packets, and Accept
incoming fragmented UDP packets.
Click Firewall and click General Setup to open the general setup page.
Call Filter Check Enable to activate the Call Filter function. Assign a start
filter set for the Call Filter.
Data Filter Check Enable to activate the Data Filter function. Assign a start
filter set for the Data Filter.
Start Filter Set Choose one of the filter sets as the base for call filer/data filter.
Action/Profile Select Pass or Block for the packets that do not match with the
filter rules.
Syslog For troubleshooting needs you can specify the filter log and/or CSM
log here by checking the box. The log will be displayed on Draytek
Syslog window.
APP Enforcement Select one of the APP Enforcement Profile settings (created in
CSM>> APP Enforcement Profile) for applying with this router.
To Next Page
Loading...
Need help?
General
