Vigor2955 User’s Guide
53
Protocol Display the protocol used for this address mapping.
Public IP Display the public IP address selected for this entry, e.g.,
86.123.123.2.
Private IP Display the private IP set for this address mapping, e.g.,
192.168.1.10
Mask Display the subnet mask selected fro this address mapping.
Status Display the status for the entry, enable or disable.
Click the index number link to open the configuration page.
Enable Check to enable this entry.
Protocol Specify the transport layer protocol. It could be TCP, UDP, or
ALL for selection.
WAN Interface Specify the WAN interface that will be used for this entry.
WAN IP Select an IP address (the selections provided here are set in IP
Alias List of Network >>WAN interface). Local host can use this
IP to connect to Internet.
To Next Page
Loading...
Need help?
General
