Mesh Node: Disconnected from Mesh network.
Range Extender: Disconnect from Wireless
Network.
Blinking AP mode: The system is scanning the surrounding
network. Or WPS is enabled and the system is
waiting for response from the wireless client.
Mesh Node: Attempting to connect to Mesh
network.
Range Extender: Connecting to Wireless Network.
Mode
On VigorAP is operating in AP mode.
Flash once VigorAP is operating as a Mesh Node.
Flash twice VigorAP is operating as a Range Extender.
Button
Factory Reset Restore the default settings. Usage: Turn on the
VigorAP (ACT LED is blinking). Press gently and
hold for more than 15 seconds. When the ACT LED
blinks rapidly, release the button and the AP will
restart with its Factory Default configuration.
LED On/Off Press it and release it within 2 seconds.
Interface Explanation
LAN
RJ-45 Gigabit Ethernet connectors for local network devices /
uplink to router.
Mesh Node & Range Extender: Connect any Ethernet network
devices, such as a PC, TV, camera or switch to use the VigorAP
802 as a wireless uplink.
To Next Page
Loading...
Need help?
General
