Need help?Do you have a question about the Draytek VigorAP 810 and is the answer not in the manual?
General| Mounting | Wall, Ceiling |
|---|---|
| Wireless Standard | 802.11a/b/g/n/ac |
| Frequency Bands | 2.4 GHz |
| Ethernet Ports | 1 x Gigabit Ethernet |
| Power over Ethernet (PoE) | Yes |
| Antenna Type | Internal |
| Security | WPA, WPA2, 802.1X |
| Management | Web-based, CLI, SNMP |
| Operating Modes | Access Point, WDS |
| Operating Temperature | 0 to 40 °C |
Provides essential safety guidelines for installing and operating the VigorAP 810 to prevent hazards.
Explains how to access and log into the VigorAP 810's web-based configuration interface.
Guides users on how to change the default administrator password for enhanced security.
Guides users through a simplified setup process for wireless and security configurations.
Describes available operation modes for the VigorAP 810 (AP, Station-Infrastructure, Bridge, Repeater) and how to select them.
Covers detailed wireless LAN configuration options when the AP is in Access Point mode.
Configuration for Universal Repeater mode, allowing the device to extend wireless network range.
Provides tools for system maintenance like status checks, password changes, backups, and firmware upgrades.
Steps to verify the hardware status of the VigorAP 810 by checking power and cable connections.
Procedures for resetting the VigorAP 810 to factory default settings via software or hardware.
To Next Page
