Need help?Do you have a question about the Draytek VigorAP 710 and is the answer not in the manual?
General| Wireless Standard | IEEE 802.11 a/b/g/n/ac |
|---|---|
| Operating Temperature | 0°C to 40°C |
| Frequency Bands | 2.4 GHz |
| Power over Ethernet | PoE (802.3af) |
| Antenna Type | Internal |
| Security | WPA3, WPA2, WPA, WEP |
| Management | Web-based, SNMP |
| Operating Modes | Access Point |
| Power Supply | 12V DC |
Verifies the hardware status of the modem.
Verifies the hardware status of the modem.
Verifies computer network settings for proper connectivity.
Verifies computer network settings for proper connectivity.
Uses ping command to check modem link status.
Resets modem to factory defaults via software or hardware.
Resets modem to factory defaults via software or hardware.
Guides through the physical setup and connection of the device.
Instructions for accessing the device's web configuration interface.
Steps to change the administrator password for security.
Configures 2.4GHz wireless settings and other options step-by-step.
Configures wireless settings when the device operates as an AP.
Sets security modes for different SSIDs.
Restricts network access using client MAC addresses.
Configures PHY mode, security, and Tx Burst for bridge modes.
Configures PHY mode, security, and Tx Burst for AP Bridge-WDS.
Sets security modes for different SSIDs in AP Bridge-WDS mode.
Restricts network access using client MAC addresses for AP Bridge-WDS.
Configures SSID and wireless channel for Universal Repeater mode.
Sets security modes for different SSIDs in Universal Repeater mode.
Restricts network access using client MAC addresses for Universal Repeater.
Configures the access point as a wireless repeater.
Configures the built-in RADIUS server for wireless authentication.
Allows setting a new administrator password for the device.
To Next Page
