Draytek VigorAP 810 - 3.6 Wireless LAN Settings for AP Bridge-Point to Point;AP Bridge-Point to Multi-Point Mode

VigorAP 810 User’s Guide
60
3
3
.
.
6
6
W
W
i
i
r
r
e
e
l
l
e
e
s
s
s
s
L
L
A
A
N
N
S
S
e
e
t
t
t
t
i
i
n
n
g
g
s
s
f
f
o
o
r
r
A
A
P
P
B
B
r
r
i
i
d
d
g
g
e
e
-
-
P
P
o
o
i
i
n
n
t
t
t
t
o
o
P
P
o
o
i
i
n
n
t
t
/
/
A
A
P
P
B
B
r
r
i
i
d
d
g
g
e
e
-
-
P
P
o
o
i
i
n
n
t
t
t
t
o
o
M
M
u
u
l
l
t
t
i
i
-
-
P
P
o
o
i
i
n
n
t
t
M
M
o
o
d
d
e
e
When you choose AP Bridge-Point to Point or Point-to Multi-Point Mode as the operation
mode, the Wireless LAN menu items will include General Setup, AP Discovery and WDS
AP Status.
AP Bridge-Point to Point allows VigorAP 810 to connect to another VigorAP 810 which
uses the same mode. All wired Ethernet clients of both VigorAP 810s will be connected
together.
Point-to Multi-Point Mode allows AP 810 to connect up to four AP 810s which uses the
same mode. All wired Ethernet clients of every VigorAP 810 will be connected together.
3
3
.
.
6
6
.
.
1
1
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
By clicking the General Setup, a new web page will appear so that you could configure the
Phy mode, security, Tx Burst and choose proper mode. Please refer to the following figure
for more information.