- 20 -
4 IMPORTANT NOTICES
4.1 INSTALLATION REGULATIONS
- Without a confirmation of performed electrical installation issued by an authorised company,
the warranty certificate shall be void.
- Check and exchange the Mg anode regularly.
- You have to apply for approval of a local power supplier to connect the heater.
- No stop valves can be put between the heater and the safety valve.
- If the overpressure in the water main exceeds 0.48 MPa, a pressure control valve must be mounted
before the safety valve.
- All hot water outputs must have a combination faucet.
- Before filling the heater with water for the first time, it is recommended to fasten the flange
connection nuts of the tank.
- It is not allowed to handle the thermostat, aside from temperature resetting with a control button.
- All electric installation handling, adjustment and replacement of the regulation elements shall only
be performed by an authorised service company.
- The thermal fuse must not be turned off! In case of thermostat defect, the thermal fuse interrupts
electric power input to the heating element if the water temperature in the heater exceeds 90 °C.
- As an exception, the thermal fuse may also switch off due to water overheating caused
by overheating the hot water heating system boiler (in case of a combined heater).
- We recommend you operate the heater with one type of energy.
- If you don't use the heater (hot water tank) for longer than 24 hours, or if the facility with heater is
unattended, close the cold water inlet to the heater.
- The heater (hot water tank) shall be used exclusively in accordance with the conditions specified
on the performance plate and in the instructions for electric wiring.
and regulations relevant in the country of use!
4.2 ACCESSORIES AND SPARE PARTS
The product is supplied with a safety valve, elements to be used for suspension of the heater on the wall,
i.e. a bracket (bended stiffened tubes). The above parts are packed and placed in the packaging in the top
part of the heater.
Also additional fastening elements – hinges – can be purchased with the heater.
It is a set of two hinges and bolts to fasten them to the heater, and an earthing bolt. The catalogue number
of this set is 102000702.
It is in your own interest to check the completeness of the accessories.
To Next Page
Loading...
