2. Place right and left wing panels on table as shown below, upside down with wing roots (centers) aligned
with edge of table.
3. Apply masking tape to flat side of each dihedral brace as shown. Tape should be slightly longer than each
brace.
4. Apply a small bead of medium instant glue to front and rear dihedral brace recesses on bottom of left
foam wing panel as shown.
5. Insert longer Front Dihedral Brace into molded dihedral slot in left foam wing and press firmly in place.
Using your finger, secure masking tape over glue joint, ensuring brace is flush in wing. Install shorter Rear
Dihedral Brace in same manner as shown below.
To Next Page
Loading...
