PRE-FLIGHT CHECK
1. Ensure transmitter and receiver batteries are fully charged.
2. Check balance of glider and control surface deflections one last time. Make adjustments if necessary. It is
always important to do this check before each flight.
3. Turn on transmitter, then glider, by plugging battery lead into receiver - observe proper polarity!
4. Refer to table and graphic to verify proper
control surface movements. Hold glider with
nose facing away from you and verify that
control stick inputs result in correct control
surface movements.
5. Check for any binding or interference between
moving parts and do a range test according to
your transmitter’s instructions. You are now
ready for the maiden flight!
Roll Right: Right aileron up, Left aileron down
Roll Left: Left aileron up, Right aileron down
To Next Page
Loading...
