Dream-Flight Libelle - Required Items for Completion

ITEMS REQUIRED FOR COMPLETION (not included)
Radio Gear:
 Programmable 6 channel radio system with flaperon mixing (see chart for transmitter suggestions)
 Micro receiver, 4-6 gram weight (see chart below for receiver suggestions)
 (4) Sub-micro servos (Part DFFA005 recommended, or purchase our Libelle flight pack, Part DFFA007)
 (2) Lightweight aileron extensions, 120mm long (Part DFLB109)
 Receiver battery: 4.8V 300mAh 1/3AA NiMH (Part DFFA001)
Adhesives and Tape:
 Medium instant glue (“CA” or Cyanoacrylate glue)
 Hot glue gun (use only low temperature craft variety)
 20-25mm (1”) wide painters masking tape – we like the blue or green stuff by 3M!
 20mm (3/4”) wide clear, non-yellowing office tape
Tools and Extras:
 Small screwdrivers (both Phillips and flathead styles)
 Small wire or nail clippers
 Small needle-nose pliers
 Scissors and sharp hobby knife
 Ruler or measuring tape
 Right angle (90º) square
 Thin permanent marker
 Small balance weights - try our non-lead Steel Balance Weights (Part DFAA002)
 Paper towels for cleaning glue excess
 A bit of fine grit sandpaper
Optional:
 Wing reinforcement decal (Part DFLB111)
 Double-sided tape for servo and radio gear installation (thin variety without foam)
 Packing tape and strapping tape for airframe reinforcement and repair
 Acrylic paints - add your personal style! Remember to clean foam with denatured alcohol first.
Suggested Transmitters and Receivers:
Transmitters
Receiver
Futaba
T6J, *T8J
*R2106GF
Hitec
Optic 6 Sport, Aurora 9
Minima 6L
*We used the Futaba T8J 2.4GHz transmitter
and Futaba R2106GF receiver for our own
setup. The R2106GF receiver's extremely short
antenna makes installation a breeze! The T8J
transmitter features a special built-on antenna
for durability, and boasts easy to use, yet very
comprehensive, programming features.
2.