SPECIFICATIONS
GENERAL SPECIFICATIONS
200 3000 4000 4200
Rated Power (W) 125 130 175 175
Voltage Rating
50-60 Hz
50 Hz
50-60 Hz
50-60 Hz
Collet Capacity
Rated Speed (n)
RPM
RPM
RPM
RPM
Construction
Double insulated construction tools
EXTENSION CORDS
MOTOR SPECIFICATIONS
Only 3000
ASSEMBLY
GENERAL
polishing.
A. Collet nut
B. Collet
C.
Twist™ integrated
wrench/nose cap
D. Shaft lock button
On/Off switch
Hanger
Power cord
H. Brush cover
Ventilation openings
Variable speed dial
K. Collet wrench
Only 4200
L.
M.
COLLETS
A. Collet nut
NOTE: Some multitool kits may not include all four collet
sizes. Collets are available separately.
CHANGING COLLETS
A. Collet nut
D. Shaft lock button
K. Collet wrench
S. To loosen
T. To tighten
1.
shaft by hand until it engages the shaft lock. Do not
2.
3.
4.
the nut when there is no bit or accessory installed.
CHANGING ACCESSORIES
1. Press the shaft lock button and rotate the shaft by
hand until it engages the shaft lock. Do not engage the
2.
necessary.
3.
4.
collet nut until the bit or accessory shank is gripped by
the collet.
NOTE: Be sure to read the instructions supplied with
your Dremel accessory for further information on its
use.
EZ TWIST™ INTEGRATED WRENCH/NOSE CAP
Only 3000 and 4000
This nose cap has an integrated wrench allowing you to
loosen and tighten the collet nut without the use of the
standard collet wrench.
1.
insert on inside of the cap with the collet nut.
2. With the shaft lock engaged twist nose cap counter
clockwise to loosen the collet nut. Do not engage the
3.
24
To Next Page
Loading...
