Settings for Approximate Revolutions
200 Model
Switch Settings Speed Range (RPM)
Low
High
3000 Model
Switch Settings Speed Range (RPM)
1-2
3-4
5-6
7-8
9-10
4000 and 4200 Model
Switch Settings Speed Range (RPM)
5
10
*15
20
25
30
33 (4000 only)
35 (4200 only)
* Do not exceed 15,000 RPM when using wire brushes.
Refer to the Speed Settings chart on pages 4-7 to help
on and the accessory to use.
heat and should be worked on at relatively low speeds.
using lower speed settings. Higher speeds are better for
•
•
• Wood should be cut at high speed.
•
•
indicates that it is running too slowly.
•
or other suitable lubricant on the cutter to prevent the
NOTE: Increasing pressure on the tool is not the answer
when it is not performing properly. Try a different accessory
or speed setting to achieve the desired result.
MAINTENANCE AND REPAIR
WARNING
ALWAYS UNPLUG THE TOOL FROM
THE POWER SOURCE BEFORE YOU
MAKE ANY ADJUSTMENTS, CHANGE ACCESSORIES,
SERVICE, CLEAN, ETC. THIS REDUCES THE RISK OF
STARTING THE TOOL ACCIDENTALLY.
!
WARNING
HAVE YOUR POWER TOOL
SERVICED BY A QUALIFIED REPAIR
PERSON WHO USES ONLY IDENTICAL REPLACEMENT
PARTS. WE RECOMMEND THAT ALL TOOL SERVICE BE
PERFORMED BY A DREMEL SERVICE CENTRE. THIS
WILL ENSURE THE SAFETY OF THE TOOL.
MAINTENANCE PERFORMED BY UNAUTHORIZED
PERSONNEL CAN RESULT IN INCORRECT CONNECTION
OF INTERNAL WIRING AND COMPONENTS WHICH CAN
CAUSE SERIOUS HAZARD.
NOTE
You can only inspect and replace the carbon brushes.
There are no other serviceable parts inside the tool.
CLEANING
1.
!
WARNING
DO NOT CLEAN THE TOOL BY
INSERTING POINTED OBJECTS
THROUGH AN OPENING.
WARNING
WEAR SAFETY GOGGLES TO
PROTECT YOUR EYES.
2.
!
WARNING
DO NOT CLEAN THE TOOL WITH
CLEANING AGENTS AND SOLVENTS,
SUCH AS GASOLINE, CARBON TETRACHLORIDE,
CHLORINATED CLEANING SOLVENTS, AMMONIA AND
HOUSEHOLD DETERGENTS THAT CONTAIN AMMONIA.
THEY CAN CAUSE DAMAGE TO THE PLASTIC PARTS.
MAINTAINING THE CARBON BRUSHES
Excluding 4000
brushes for wear every 40-50 hours of use. Also inspect
!
WARNING
USING THE TOOL WITH WORN
BRUSHES WILL PERMANENTLY
DAMAGE THE MOTOR. USE ONLY ORIGINAL DREMEL
REPLACEMENT BRUSHES.
1.
2.
(4200).
3.
4.
replace the carbon brush by a new one.
a.
26
To Next Page
Loading...
