Dremel 2050 - Accessory Speed Dial Setting Guide; Cutters and Diamond Wheel Speed Settings; Polishing, Brushing, and Sanding Speeds

14
Set speed dial to the setting recommended for the material being worked and the catalog
number of accessory being used. For speed range for each setting please refer to “Operating
Speeds” on page 13.
Speed Dial Settings
High Speed Cutters
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
191 5 5 2 3-4 5 - - -
125 5 3-4 2 3-4 3-4 - - -
Engraving Cutters
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
105 5 5 5 2 3-4 - - -
Diamond Wheel Points
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
7103 5 5 - - - 5 5 5
Polishing Accessories
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
414, 429 - - - 3-4 3-4 3-4 3-4 3-4
Wire Brushes
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
428 2-3 2-3 1 2-3 2-3 - - -
Sanding Bands and Discs
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
430, 431, 438 1-5 1-5 1-4 5 5 1-5 1-5 -
Use only Dremel
®
, high-performance accessories.
Questions or Problems? Call 1-800-437-3635
or check our website at www.Dremel.com
2610Z09741 12-17 2050.qxp_2050 12/19/17 10:38 AM Page 14