25
TOOLS > ABOUT THIS DEVICE
This screen displays laser cutter hardware and
software information.
MODEL NUMBER — Displays unit model number.
SERIAL NUMBER — Displays unit serial number.
FIRMWARE NUMBER — Displays the currently
installed firmware version.
USAGE — Displays total hours of time that jobs have
been run.
WIRED IP — Displays Ethernet IP address, if
connected.
WIRELESS IP — Displays IP address assigned by
wireless router.
MAC ADDRESS — Displays unique identifier assigned
to a network interface controller.
FCC ID — Displays FCC ID
IC ID — Displays IC ID
LCD TOUCH SCREEN
TOOLS > FACTORY RESET
This screen allows for verification of factory reset
selection.
BACK – Tap to cancel factory reset and
return to Tools > Menu Screen.
RESET – Tap to perform factory reset.
NOTE - The following actions occur when Factory Reset is
performed:
• EULA screen will appear on next power up and needs to be
accepted.
• Country and Language selection will appear on next power cycle.
• Job history on the LCD software Interface will be cleared.
• Default material settings will be restored for the Laser browser
interface software.
• User custom material settings will be cleared.
• Network configuration will be restored to default with all custom
settings cleared.
• Saved wireless network and password will be cleared.
• Ventilation setting will revert back to default of EXTERNAL
FILTRATION/VENTILATION SYSTEM.
To Next Page
Loading...
Need help?
General
