Dremel DIGILAB LC40 - SETUP (continued); Network Setups - Peer to Peer Ethernet; Network Setups - Multiple Lasers via Ethernet

60
SETUP
Network Setups
PEER TO PEER ETHERNET CONNECTION
Scenario 1: Connecting the laser to a single computer using Ethernet connection.
• Optional: If the computer has a second Ethernet port or built-in wireless, the
computer can access both the internet and the laser unit.
• The laser unit does not have access to the Internet (optional for Laser connection)
unless the computer bridges/shares the Internet connection.
Note: The laser does have the option to set a Static IP address using the LCD software
interface.
Scenario 2: Connecting two or more laser units to a single computer using Ethernet
connection.
A computer that has two or more Ethernet ports may connect to additional Laser
Cutters.
• Optional: If the computer has has an additional, separate Ethernet port or built-in
wireless, the computer can access both the internet and the laser unit.
• The laser unit does not have access to the Internet (optional for Laser connection)
unless the computer bridges/shares the Internet connection.
OR
Wireless or Ethernet
Router Internet
Ethernet
Ethernet
Fig. 28
Ethernet
OR
Wireless or Ethernet
Router Internet
Fig. 27