27
This screen displays the option to turn ON or OFF
the LED lights that illuminate the workspace.
LED ON/OFF — Turns “ON” and “OFF” LED lights.
LED lights are “ON” by default. If the main power
switch is cycled, the light setting will return to the
default.
LCD TOUCH SCREEN
TOOLS > SETTINGS > LIGHTS
This screen provides an option to select between
the internal vent fan and external ventilation systems
such as a booster fan, a standalone filtration system,
or an external fume ventilation system.
To assure proper removal of fumes produced during
operation of Dremel LC40 laser cutter, the
ventilation selection must match the actual fume
extraction set up. Dremel LC40 must be set up
according to instructions provided in the Exhaust
Connections chapter of the Setup section on page
XYZ to assure proper ventilation.
ONBOARD FAN — Select when only the vent fan in
the laser cutter is used to exhaust workspace fumes.
EXTERNAL SYSTEM — Select if laser unit is
connected to a booster fan, standalone filtration
system, or an external fume ventilation system.
TOOLS > SETTINGS > VENTILATION
To Next Page
Loading...
Need help?
General
