07-01913F F515 8 Dri-Eaz Products, Inc.
TROUBLESHOOTING
Water drips out
when moving unit
Unit was unplugged before
purging was complete.
Purge unit before moving. See “At the End of the Job,” p. 4.
Plug in unit; check power cord connection at wall outlet and at
base of unit.
Remove duct ring and grill and remove obstruction. Replace
duct ring and grill.
Unit operating,
but room not dry
Poor air movement in room.
Excessive moist air infiltration.
Allow more time for drying.
Increase air movement with air movers.
Seal off area to reduce infiltration.
Unit collects too
little water
Room temperature is too low.
Air filter is full.
Heat exchange block and/or
coils are clogged.
Confirm humidity level with hygrometer.
Increase room temperature.
Check filter. Clean or replace as necessary.
Check heat exchange block and coils. Clean as necessary.
If the problem you are experiencing is not listed here, call your local distributor or contact
our Service Department at 800-932-3030 for further assistance.
SPECIFICATIONS
PHD 200 Dehumidifier
Model F515
12.5 × 17.6 × 21.5 in.
31.8 × 44.7 × 130.8 cm
74 pts/day | 35 L/day
at 80°F/60% RH (AHAM)
120 pts/day | 57 L/day
at 90°F/90% RH
Operating temperature range
Specifications are subject to change without notice. Some values
may be approximate.
PARTS INCLUDED
40 ft. (12 m) of drain hose with quick-connect fitting.
6 ft. (1.8 m) detachable power cord.
1 disposable air filter (reorder F527)
OPTIONAL
Duct Attachment Kit (F530)
FOR PARTS AND SERVICE CALL YOUR LOCAL DIS-
TRIBUTOR or Dri-Eaz at 800-932-3030.
www.Dri-Eaz.com
Visit warranty.DriEaz.com and register your purchase to
ensure you receive any important product releases.
To Next Page
Loading...
