21www.drilldoctor.com
• If the problem persists contact the Technical Service Depart-
ment.
4. Question:
Why is the drill point o center?
Answer:
If the tip of the drill bit appears to be sharpened o center, check
the following items:
• Your drill may be bent.
• Make sure the Chuck is clean.
• During the sharpening process be sure to keep the same pres-
sure on each half-turn.
5. Question:
What can I do about at spots on the bit point between the
Cutting Edge and the Heel?
Answer:
The at spots on a sharpened bit are the result of an incomplete or
paused half-turn of the Chuck in the Sharpening Port. To correct,
apply light, inward pressure and rotate the Chuck smoothly from
white line to white line while sharpening. Be sure to complete the
half-turns.
6. Question:
Why is the Chisel Edge on my drill bit at?
Answer:
During the alignment process the Alignment Fingers may have
been gripping the high points of the drill bit. Reinsert the drill bit
in the Chuck making sure that the Alignment Fingers grip the nar-
rowest section of the bit (the utes) and the Leading Edge of the
Flute is against the Alignment Finger.
To Next Page
Loading...
