Page 12 For technical questions, please call 1-800-444-3353. SKU 66965
Troubleshooting
Problem Possible Causes Likely Solutions
Tool will not start. No power at outlet during 1.
charging.
Internal damage or wear. 2.
(Carbon brushes or switch, for
example.)
1. Check power at outlet. If outlet is
unpowered, turn off tool and check circuit
breaker. If breaker is tripped, make sure
circuit is right capacity for tool and circuit
has no other loads.
2. Have technician service tool.
Performance
decreases over time.
Accessory dull or damaged. 1.
Carbon brushes worn or 2.
damaged.
Keep accessories sharp. Replace as 1.
needed.
2.
brushes.
Excessive noise or
rattling.
Internal damage or wear. (Carbon
brushes or bearings, for example.)
Have technician service tool.
Forcing tool to work too fast.
1.
Accessory misaligned. 2.
Accessory dull or damaged. 3.
Blocked motor housing vents.4.
Allow tool to work at its own rate.1.
Check and correct accessory to fence 2.
and/or table alignment.
Keep cutting accessories sharp. 3.
Replace as needed.
Wear ANSI-approved safety goggles and 4.
while blowing dust out of motor using
compressed air.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
To Next Page
Loading...
