Drive 15561 - TECHNICAL SPECIFICATIONS; BED DIMENSIONS AND WEIGHT CAPACITY

11
TECHNICAL SPECIFICATIONS
Overall Length 87.2”
Overall Width w/o Rails 35.63”
Overall Width w/Rails 37”
Length & Width of Mattress Deck 79.73” x 34.65”
Maximum Weight Capacity 450lbs. includes all accessories
Head Deck Angle 0°to 68°
Foot Deck Angle 0°to 30°
Height Range
Manual Bed Ends 11” to 20”
Crank Bed Ends 15.1” to 22.5”
Under Bed Clearance
Manual Bed Ends 4.4”
Crank Bed Ends 8.3”
Total Product Weight
Head Section 41lbs
Foot Section 41lbs
Manual Bed Ends 44lbs
Crank Bed Ends 52lbs
Noise Level ≤65dB(A)
Electrical Requirements 120VAC,60Hz
Rated Current Input 1.8A max
Fuse Specication 2A 250V
Duty Cycle T_On 2 Min / T_Off 18 Min
Battery Backup: Handset (1) & Motor (2) 9V
Relative Humidity 15% to 93% relative humidity, non-condensing
Recommended Storage &Shipping Temperature -22°F to +158°F
Recommended Operating Temperature 41°F to 104°F
Atmospheric Pressure Range 700hPa to 1060hPa
OPERATING TEMPERATURE
If bed has been stored in an area where the temperature is above or below the Recommended Operating Temperature
range of 41°F to 104°F. You must wait at least 30 minutes for the bed temperature to adjust to the Recommended
Operating Temperature range of 41°F to 104°F before use.
BED SERIAL NUMBERS
When ordering parts or when contacting Drive DeVilbiss Healthcare Customer Service Department, please include bed’s
model and serial numbers, found on the identication labels as below. The identication labels are located under the sleep
deck on the either side of the bed frame.
COMPLIANCE INFORMATION
Matching the correct bed components to meet regulatory specications can be complicated. Drive DeVilbiss Healthcare
offers a wide variety of compliance options and we can assist your facility in selecting components or accessories that are
recommended for the specic bed model.