Trident HD Owner’s Manual www.drivemedical.com
Your power wheelchair requires assembly prior to initial use. Please be sure to follow
these steps to properly set up your power wheelchair.
Step 1:
Remove the rear cover, and slide the rear
tray out from underneath the
powerchair by lifting up on the pull-ring
on the back of the chair while sliding the
tray towards the back of the powerchair.
Step 2:
Connect the wire harness lead from the
battery pack to the main power harness
on the rear of the powerchair.
Step 3:
Push the battery tray forward until the
pull-ring locks into place on the frame.
To Next Page
Loading...
