2524
Riding and throttle control instructions (continued)
6) When the slow-start safety mechanism is automatically turned off, the throttle can then be fully engaged
where the amount of rotation on the throttle grip controls the speed level adjustment (up to the maximum
7)
When the rider rotates the throttle grip, the speed will increase. When the rider gradually releases the
throttle grip, the speed will decrease.
8)
While powered on with the throttle engaged, the product will continuously move forward, until the
throttle is fully released and the brake is engaged. **
9)
There is NO REVERSE function for this product. The product moves in a forward motion ONLY, when
**
It is strongly recommended that the rider and parental / adult supervisor conduct multiple short practice
runs (how to ride, stop, and brake safely) in a safe location at the lowest speed level, only GRADUALLY
increasing the speed when all parties are comfortable doing so.
desired speed limit set by the parental control speed limit key).
powered on and the throttle and motor are engaged.
10) The rider should KEEP HANDS ON HANDLEBARS AT ALL TIMES and KEEP BOTH FEET ON THE
Parental or adult supervision is required AT ALL TIMES when the product is in use and the rider
Stopping and braking
is following the braking instructions below:
1) To stop the product safely, engage the brake by gradually releasing the THROTTLE
and depressing the BRAKE LEVER next to the left handlebar.
2) If the product is going at a higher speed, first LOWER the speed by GRADUALLY releasing the
throttle grip, then release it entirely before depressing the brake lever.
3) Depressing the brake will disengage power to the motor.
4) Once the product has come to a complete stop at a safe location, the rider’s feet should be
lowered from the footrests to the ground.
5) If the rider is disembarking from the product, first lower the kickstand to the ground, ensure that it
is all the way lowered, and gradually release the handlebars until the product is safely leaning
onto the kickstand.
6) After each use of the product, ensure that it is POWERED OFF safely by:
• Turning the ignition key to the OFF position, then removing the key.
• Pressing the headlight switch (if on) to the OFF position.
• Following charging instructions on page 5.
FOOTRESTS AT ALL TIMES while the product is in use.
To Next Page
Loading...
General