Drucker Diagnostics +1-814-692-7661 - CustomerService@DruckerDiagnostics.com Page | 4
INITIAL SETUP PROCEDURE
If any problems are found during the initial setup procedure, refer to the
troubleshooting section on page 9. For further assistance, contact
Drucker Diagnostics at 814-692-7661.
1. Plug the centrifuge in to an approved electrical outlet. For
electrical safety, the unit must always be properly grounded.
2. Turn the latch counter–clockwise and open the lid.
3. Spin the rotor by hand; check for free and level rotation.
4. Close the lid. Rotate the lid knob clockwise to its complete stop
position.
5. Turn the centrifuge on by turning the timer to 10 minutes.
6. Listen to the centrifuge. A smooth whirring sound should be
heard.
After the centrifuge has passed this procedure it is ready for operation.
To Next Page
Loading...
Need help?
General
