DSC 3G2080E - User Manual

TL280LE(R) / TL280LE-EU /
TL280LE-LAT / TL280LE-AU
Internet and LTE/HSPA Dual-Path Alarm
Communicator
LE2080(R) / LE2080-EU / LE2080-
LAT / LE2080-AU
LTE/HSPA Alarm Communicator
3G2080(R)E
HSPA Cellular Alarm Communicator
TL2803G(R)E
Internet and HSPA Dual-Path Alarm Communicator
TL280(R)E
Internet Alarm Communicator
Installation Manual 5.X
Warning: This manual contains information on limitations regarding product use and function and information on the
limitations as to the liability of the manufacturer. The entire manual should be carefully read.
Please note that not all models and features listed are available in all markets.

Summary

Installer Warnings and Guidance

Installer Notes and Responsibilities

General Product Overview

User Safety Information

Instructions for users on safe operation, servicing, and handling of the equipment.

Supported Model Information

Lists the alarm communicator models covered by the manual and their regional specifications.

Product Features and Specifications

Key Product Features

Detailed Technical Specifications

Provides technical specifications for the communicator, including standards compliance.

EN50131-1 Installation Requirements

Programming options required for EN50131-1 compliant installations.

Communicator Installation Configuration

Compatible Receivers and Panels

Pre-Installation Configuration Steps

Ethernet Cable Installation

Instructions for installing the CAT 5 Ethernet cable for TL models.

SIM Card and RS-232 Cable Installation

SIM Card Insertion and Removal

Communicator Placement and Signal Testing

Placement Test Procedure

Procedure to test cellular antenna location suitability for radio operation.

Initial Panel Programming and Activation

Initial Panel Programming Steps

Steps for initial programming of the panel and communicator.

Activation with C24 Communications

SMS Command and Control Features

SMS Command List

Communicator Status LED Indicators

Yellow Trouble LED Interpretation

Meaning of the yellow trouble LED and its flash codes.

Trouble Indicators and LED Status

Panel Supervision and Cellular Troubles

Ethernet and Receiver Troubles

Supervision, FTC, and Module Troubles

Red Network Connection Status LED

Green Signal Strength LEDs

Communicator Reset and Firmware Update

Factory Defaults Reset Procedure

Steps to restore the communicator to its factory default settings.

Firmware Update Process

Information on how to update the communicator's firmware.

Communicator Troubleshooting Guide

Trouble Indications and Solutions

Table detailing trouble indications, possible causes, and solutions.

Ethernet;Cellular Programming Options

System Options Configuration

Configuration settings related to the system's operation and network.

Ethernet Network Settings

Settings for Ethernet IP Address, Subnet Mask, and Gateway.

System Toggle Options

Communication and System Settings

Account Code and Communications Format

Communications Reporting Codes

System Test Transmission Configuration

Primary;Secondary Receiver Test Options

Unique Primary;Secondary Receiver Tests

Ethernet Receiver Configuration

Ethernet Receiver 1 Options

Ethernet Receiver 2 Options

Cellular Receiver Configuration

Cellular Receiver 1 Options

Cellular Receiver 2 Options

Cellular Network and SMS Options

Cellular Network Settings

SMS Event Notification and Control

Integration Settings

Session 1 Integration Toggle Options

Diagnostic Testing and System Information

Receiver Diagnostic Testing Procedure

Procedure to force test transmissions to verify communications paths.

Response Code Descriptions and Actions

Communicator Status and Signal Strength

Communicator Status Interpretation

Details on how communicator status is displayed and interpreted.

Radio Signal Strength Indicators

Table showing radio signal strength indicators and actions.

Network Usage and Security Recommendations

DSC 3G2080E Specifications