DSC GSM0110

3
For example, if options 1 and 2 are on,
the display will look like:
For information on programming the rest
of your security system, please refer to
your system’s Installation Manual.
Function Key Options
The function keys are programed in sec-
tions [000][1-4]. By default, the 4 function
keys on the keypad are programmed as
Stay Arm (03), Away Arm (04), Chime
(06), Aux (11). You can change the func-
tion of each key on every keypad. Please
see your system’s Installation Manual for
instructions on programming the keys,
and a complete list of all the function key
options available for your system.
Clock Options
The LCD5511 will display the current
time after 4 seconds of no key presses.
To set the correct time and date for the
system, please refer to your system’s In-
struction Manual. You can change how
the keypad displays the time with the fol-
lowing options. To change the clock op-
tions:
1. Enter [
✱
][8][Installer’s code]
2. Enter [000] to go to keypad program-
ming
3. Enter section [6] to go to clock op-
tions.
4. To turn any of the options on or off,
press [1], [2], or [3]:
NOTE: If the Time does not display on keypad
option is selected, make sure that the Keypad
displays time when zones are open option is
also selected.
[1] ON =Time displays on keypad
OFF =Time does not display on
keypad
[2] ON = Clock display is in 12-hour
format (e.g. 08:00).
OFF =Clock display is in 24-hour
format (e.g. 20:00)
[3] ON =Keypad does not display time
when zones are open
OFF =Keypad displays time when
zones are open
5. When you are finished programming
the clock options, press [#] to exit.
Alarms Displayed While Armed Option
You can disable the display of alarms on
the keypad when the system is armed.
The display of alarms is enabled by de-
fault. To disable the display of alarms
when the system is armed, turn off sec-
tion [6], option [5]:
1. Enter [
✱
][8][Installer’s code]
2. Enter [000] to go to keypad program-
ming
3. To turn the display of alarms on or off,
enter section [6].
4. Turn option [5] on or off:
>@ 21
= Alarms not displayed
while system is armed
2))
= Alarms are always dis-
played while system is armed
5. When you are finished, press [#] to exit.
Emergency Key Options (Fire, Auxiliary,
Panic)
You can enable or disable the Fire, Auxil-
iary and Panic keys at each keypad.
These keys are enabled by default.
Please see your system’s Installation Man-
ual for more information on these keys and
their options. To turn any of the emergen-
cy keys on or off on the keypad:
1. Enter [
✱
][8][Installer’s code]
2. Enter [000] to go to keypad program-
ming
3. Enter section [7].
4. To turn the emergency key options on
or off, press [1], [2], or [3]:
[1] ON = Fire key enabled
OFF = Fire key disabled
[2] ON = Auxiliary key enabled
OFF = Auxiliary key disabled
[3] ON = Panic key enabled
OFF = Panic key disabled
5. When complete, press [#] to exit.
alarm shop