DSC HS2016 User Manual

4 Securing the Premises
14
4.1.5 Leaving when the System is Already Armed - Quick Exit
Use the Quick Exit feature if the system is already armed and you would like to leave without disarming
and rearming the system. Quick Exit uses the same hot keys as Quick Arming, and it provides you with a
two minute exit delay to leave the premises without triggering an alarm. Once the door you leave from
closes, the exit delay timer will be cancelled.
4.1.6 Exit Delay Time Restart
The control panel provides an option where, if a entry/exit zone is tripped a second time prior to the end of
the exit delay, the exit delay time restarts. The exit delay timer can only be restarted once.
4.2 Arming the system with a 2-way wireless key
If configured, the PowerSeries Neo system can be armed using the following wireless keys:
• PG4929/PG8929/PG9929
• PG4939/PG8939/PG9939
4.3 Arming the system with a Proximity tag
If configured, the PowerSeries Neo system can be armed using MPT proximity tags.
4.4 Bypassing Zones
Bypassing zones intentionally unprotects specified zones the next time your system is armed. Depending
on the type of keypad, bypassed zones will be identified differently. Using an HS2LCD series keypad,
bypassed zones are indicated on the LCD screen as shown in Table 4-1. If using an LED or ICN series
keypad, the will light and the bypassed zones #s will be shown.
To Quick Exit LCD Display
1. When the system is already armed and the Armed light is lit, press and hold
the Quick Exit key for 2 seconds
OR
press .
Quick Exit in
Progress
2. Exit the premises before the exit delay timer expires. After exiting, the delay
timer will be cancelled.
To Arm the System with a 2-way wireless key
• Press the desired Arming mode button anytime the system Ready indicator is on.
To Arm the System with a Proximity tag
• Present your Proximity tag to a keypad equipped with a proximity sensor anytime the system Ready
indicator is on.
• If configured by your installer, enter your access code.
WARNING: If a zone is not operating properly contact a service person immediately.
*
0

DSC HS2016 Specifications

General

Mounting Type	Wall mount
Power Supply	16.5VAC
Battery Backup	12VDC
Operating Temperature	32°F to 120°F (0°C to 49°C)
Dimensions	267mm