DSC HS2016 User Manual

8 Configuring User Functions
31
8.1.3 Enabling/Disabling the Auto Arm/Disarm Feature
8.1.4 Setting the Auto Arm Time
The system can be configured to Auto arm at a specific time on each day of the week. If a specific time is
not configured for a day of the week the system will not arm automatically on that day.
8.1.5 Allowing the Installer to Service your System Remotely - DLS
Occasionally, your installer may need to remotely access the Installer programming of your security system
using Downloading Software (DLS). In order for this to successfully occur, you may need to manually
allow access to your system.
NOTE: Access to this feature must be configured by installer.
To enable/disable Auto Arm/Disarm LCD Display
1. From the User Function menu use the shortcut key or press
to scroll to Auto Arm/Disarm.
Press (*) for <>
Auto Arm/Disarm
2. Press to enable/disable the Auto Arm/Disarm feature.
Auto Arm/Disarm
is Enabled
or
3. When finished press to return to the Ready state.
Auto Arm/Disarm
is Disabled
NOTE: Access to this feature must be configured by installer.
To set the Auto Arm Time LCD Display
1. From the User Function menu use the shortcut key or press
to scroll to Auto Arm Time.
Press (*) for <>
Auto Arm Time
2. Press to open a days of the week sub menu. Scroll the days of the week
and press to set the time for that day.
OR
If using an ICN or LED keypad to select the desired day press [1-7] where 1=
Sunday and 7=Saturday.
Press (*) for <>
Sunday
3. Using a 24 hour format, set the desired time. After you enter the fourth digit
the screen will revert back to the previous day of the week menu. Entering the
time 9999 disables the late to open feature for that day. When using an ICN or
LED keypad the time will not display.
Set 24Hr Time
Enter HH:MM 9999
4. Continue setting the time for the desired days of the week. When finished
press to return to the Ready state.
Set 24Hr Time
Enter HH:MM 9999
NOTE: If you set an invalid time the error tone will sound.
NOTE: Access to this feature must be configured by installer.
To enable/disable the System Service/DLS LCD Display
1. From the User Function menu use the shortcut key or press
to scroll to SystemServ/DLS.
Press (*) for <>
SystemServ/DLS
0
2
*
#
0
3
*
*
#
0
5

DSC HS2016 Specifications

General

Mounting Type	Wall mount
Power Supply	16.5VAC
Battery Backup	12VDC
Operating Temperature	32°F to 120°F (0°C to 49°C)
Dimensions	267mm