17
Section 2: Access Codes
cannot program other Supervisor codes, or System Master codes. For a
list of the other user options that are enabled for this code, see Table 2-1.
Duress Codes
If the “Duress” user option is enabled, the code will become a Duress
code. When this code is entered, the system will send a duress signal to
the monitoring station. Make sure that the Arm and Disarm user options
are also enabled for this code.
One-time Use Codes
If the “One-time Use” option is enabled, the code will become a One-time
Use code. The code can be used to disarm assigned partitions. When a
user arms the system using a One-Time Use code, the panel will erase the
code once the Exit Delay expires; after this time, the code cannot be used
again. Make sure that the Arm and Disarm user options are also enabled
for this code.
Log Only Codes
A “Log Only” code will only create an entry in the event buffer when
entered at a keypad. Example: a log-only code may be used by a guard to
record the time that they checked each area of the premises.
To create a log-only code, disable all the access code options for the code.
Temporary Codes
A “Temporary code” is an access code that can be turned on or off by
partition using the “T-Code” function key. Any code with the temporary
code attribute enabled will work this way.
To turn temporary codes on for a partition, press and hold the “T-Code”
function key at a keypad assigned to the partition. You may need to enter
an access code after pressing the “T-Code” key.
If enabled for your access code, you can also turn temporary codes on
and off for any partition by entering [*][6][access code][0][3].
2.7 Installer Programmed Codes
These are access codes that are programmed by your installer. Talk to
your installer for more information regarding these codes.
• Second Master Code: This code has the same properties as the
System Grand Master code. Only your installer can program this
code.
• Walk Test Code: The Walk Test code is used to access to the walk test
mode. See Section 5.1 “Walk Test” for instructions on performing a
walk test.
• Guard Code: This code is only valid when a partition is disarmed
and for a programmed amount of time after a partition is armed
using the Guard code. Only your installer can program the Guard
code.
To Next Page
Loading...
Need help?
General
