DSC MAXSYS PC4020 - Adding Tenant Codes for Users

27
Section 4: Access Control
4.5 Adding Tenant Codes for Users (PC4850 Modules)
You can give visitors the option of entering a 1-4 digit code on the keypad
to call a user. To do this, enter the 1-4 digit code for the apartment. If a
user knows a visitor is coming, they can give them the tenant code as a
faster way to call them. For this to work, the user’s telephone number
must also be programmed (see section 4.4).
NOTE: Tenant codes cannot begin with “0”.
1. Enter [*][5] followed by a Master code.
2. Locate the access code for the user with one of the code-searching
methods (see Section 2.2 “Modifying an Existing Code”). Press [*] to
select.
3. Use the right arrow (>) key to scroll to the following display:
Select (8) < >
Tenant Code
4. Press [8] or [*].
5. Enter up to 4 digits for the tenant code.
6. When you are finished, press [#].