DSC Neo Power HS2016 - 5.1.5 Viewing Alarms in Memory

Chapter 5
5.1.5 Viewing Alarms in Memory
When an alarm occurs the keypad indicator illuminates. Viewing the Alarm memory provides more information on the sensor(s)
that were tripped. When using a ICN or LED keypad the Memory LED will be lit and the zone numbers will be displayed.
To View Alarms in Memory LCD Display
l Press [*][3]
OR
use the scroll keys to navigate to Alarm Memory and press . The Alarm information
will display. For more information on the messages that could be displayed
see:“Alarm Messages”.
Press (*) for <>
Alarm Memory
5.1.5.1 Alarm Messages
LCD Display What it means
Burglary <>
Verified
Multipleburglarysensorsweretripped.Centralstationhasbeennotified.
Burglary Not <>
Verified
Asingleburglarysensorwastripped.Centralstationhasbeennotified.
Hold-up <>
Verified
Multiplehold-upsensorsweretripped.Centralstationhasbeennotified.
Hold-up Not <>
Verified
Asinglehold-upsensorwastripped.
Fire Alarm <>
Fire Zone 1
Firealarmhasbeentriggered.Centralstationhasbeennotified.OnanICNor
LEDkeypadthe willbelit.
CO Alarm <>
CO Zone 1 <>
COalarmhasbeentriggered.Centralstationhasbeennotified.OnanICNor
LEDkeypadthe willbelit.
5.2 Resetting Smoke Detectors
After having detected an alarm condition smoke detectors require a reset to exit the alarm condition.
Note:Verify with your alarm company if this function is required on your system.
To Reset the Sensors
1. Press and hold on the keypad for 2 seconds. If the reset is successful, the alarm is cancelled.
2. If a smoke detector fails to reset, it may still be detecting an alarm condition. If unsuccessful, the alarm will reactivate or
continue.
- 18 -