DSC TL260

37
Ethernet/Cellular Programming Worksheets 3G Alarm Communicator Installation Manual
[534] Module Supervisory Restore
Default [Module Supervisory Restore].
________________________________
[535] General System Tamper Default [General System
Tamper].
________________________________
[536] General System Tamper Restore
Default [General System Tamper Restore].
________________________________
[537] Wireless Device Low Battery
Default [Wireless Device Low Battery].
________________________________
[538] Wireless Device Low Battery Restore
Default [Wireless Device Battery Restore].
________________________________
[539] Cross Zone/Police Code Default [Burglary Verified].
________________________________
[540] Burglary Not Verified Default [Burglary Not Veri-
fied].
________________________________
[541] Duress Alarm Default [Duress Alarm].
________________________________
[542] Opening After Alarm Default [Disarmed After
Alarm].
________________________________
[543] Recent Closing Default [Alarm Occurred After Arm-
ing].
________________________________
[544] Alarm Canceled Default [Alarm Canceled].
________________________________
[545] Keypad Lockout Default [Keypad Lockout].
________________________________
[546] Exit Fault Default [Exit Fault].
________________________________
[547] Partial ClosingDefault [Armed With Zones
Bypassed].
________________________________
[548] Zone Bypass Default [Zone Bypassed].
________________________________
[549] Zone Unbypass Default [Zone Unbypassed].
________________________________
[550] Auto Arm Cancel Default [Automatic Arming Can-
celled].
________________________________
[551] Closing Default [Armed By].
________________________________
[552] Opening Label Default [Disarmed By].
________________________________
[553] Special Closing Default [Armed].
________________________________
[554] Special Opening Default [Disarmed].
________________________________
[555] Late To Open Default [Late To Open].
________________________________
[556] Delinquency Default [Delinquency].
________________________________
[557] General System Trouble Default [General System
Trouble].
________________________________
[558] General System Trouble Restore
Default [General System Trouble Restore].
________________________________
[559] AC Line Trouble Default [AC Power Failure].
________________________________
[560] AC Line Trouble Restore Default [AC Power
Restore].
________________________________
[561] Battery Trouble Default [Battery Trouble].
________________________________
[562] Battery Trouble Restore Default [Battery Restore].
________________________________
[563] Bell Circuit Trouble Default [Bell Circuit Trouble].
________________________________
[564] Bell Circuit Trouble Restore Default [Bell Circuit
Restore].
________________________________
[565] Auxiliary Power Trouble Default [Auxiliary Power
Trouble].
________________________________
[566] Auxiliary Power Trouble Restore
Default [Auxiliary Power Restore].
________________________________
[567] Ground Fault Default [Ground Fault Trouble].
________________________________
[568] Ground Fault RestoreDefault [Ground Fault Restore].
________________________________
[569] TLM Failure Default [Telephone Line Failure].
________________________________
[570] TLM Failure Restore Default [Telephone Line
Restore].
________________________________
[571] FTC Trouble Default [Fail To Communicate Trou-
ble].
________________________________
[572] FTC Restore Default [Fail To Communicate Restore].
________________________________
[573] Event Buffer 75% Full Default [Event Buffer Near
Full].
________________________________
[574] DLS Lead In Default [Remote Programming Begin].
________________________________
[575] DLS Lead Out Default [Remote Programming End].
________________________________
[576] Installer Lead In Default [Local Programming Begin].
________________________________
[577] Installer Lead Out Default [Local Programming End].
________________________________
[578] Walk Test Lead In Default [Walk Test Begin].
________________________________
[579] Walk Test Lead Out Default [Walk Test End].
________________________________
[580] System Test Default [System Test Message].