DSC TL260

38
Ethernet/Cellular Programming Worksheets 3G Alarm Communicator Installation Manual
________________________________
Internal Event Label Programming
[591] Panel Absent Trouble Default [Panel Communica-
tions
Trouble].
________________________________
[592] Panel Absent Trouble Restore
Default [Panel Communications Restored].
________________________________
[593] Module Reprogramming Default
[Communicator Programming Updated].
________________________________
[594] Firmware Update Default [System Test Message].
|____|____|
________________________________
SMS Interactive Functions
[601] Stay Arm Default [Stay Arm];
________________________________
[602] Away Arm Default [Away Arm];
________________________________
[603] Night Arm Default [Night Arm];
________________________________
[604] Disarm Default [Disarm];
________________________________
[605] Activate Command Output 1
Default [Activate Command Output 1].
________________________________
[606] Activate Command Output 2
Default [Activate Command Output 2].
________________________________
[607] Activate Command Output 3
Default [Activate Command Output 3].
________________________________
[608] Activate Command Output 4
Default [Activate Command Output 4].
________________________________
[609] Deactivate Command Output 1
Default [Deactivate Command Output 1].
________________________________
[610] Deactivate Command Output 2
Default [deactivate command output 2].
________________________________
[611] Deactivate Command Output 3
Default [Deactivate Command Output 3].
________________________________
[612] Deactivate Command Output 4
Default [Deactivate Command Output 4].
________________________________
[613] Bypass Default [Bypass];
________________________________
[614] Unbypass Default [Unbypass];
________________________________
[615] Status Request Default [Status Request];.
________________________________
[616] Alarm Memory Request Default [Alarm Memory
Request];
________________________________
[617] Help Default [Help];
________________________________
SMS Interactive Response
[621] Function Successful Default [Successful];
________________________________
[622] Function Failure Default [Unsuccessful];
________________________________
[623] Invalid Command Default [Invalid Command];
________________________________
[624] System Stay Armed Default [Stay Armed];
________________________________
[625] System Away Armed Default [Away Armed];
________________________________
[626] System Night Armed Default [Night Armed];
________________________________
[627] System Disarmed Ready Default [Disarmed Ready];
________________________________
[628] System Disarmed Not Ready Default [Disarmed Not
Ready];
________________________________
[629] System is in Alarm Default [is in Alarm];
________________________________
[630] Trouble Label Default [Service is Required];
________________________________
[631] No Alarms in Memory Default [is in Alarm];
________________________________
[901] Diagnostic Test Transmission
|___| [1] Ethernet 1 Default (OFF).
|___| [2] Ethernet 2 Default (OFF).
|___| [3] Cellular 1 Default (OFF).
|___| [4] Cellular 2 Default (OFF).
System Information (Read Only)
[988] DNS 1 IP Address
|____|____|____||____|____|____||____|____|____|____|____|____|
[989] DNS 2 IP Address
|____|____|____||____|____|____||____|____|____|____|____|____|
[991] Firmware Version
|____|____|____|____|____|____|____|____|
[992] Ethernet IP Address
|____|____|____||____|____|____||____|____|____|____|____|____|
[993] Ethernet Gateway Address
|____|____|____||____|____|____||____|____|____|____|____|____|