DTS INSIGHT FR830 - The Typical Connection Example of the Target System and Main Unit

23
FPDT(JP0_1)
3.2. The typical connection example of the target system and main unit
Connecting with Target System / Example
*1: Optional
*2: The signal is not required to be connected when it set up to the specified logic values on a
target system.
The table below lists how to set up the MODE signal
Signal
Name
Value
FLMD1 EVSS
*3: Connecting is not necessary for UART.
*4: Connecting is not necessary for one-wire UART.
*5: Use pull-up on the target for one-wire UART. Check the microcomputer’s manual,
configuration of the circuit of the programmer and the target, and communication waveform
before you set the pull-up resister value
*4
Tar
g
et S
y
stem
FPDR(JP0_0)
FPCK(JP0_2)
TC
K
TTXD
TRXD
WDT
EVSS
BVSS
/TICS
RH850/F1L
/RESET
EVCC
BVCC
TVccd
GND
NET IMPRESS
(6)
(13)
(27)
(10)
(1,14,15,28)
(2)
(18)
FLMD1
TMODE
(12)
*1
/TRES
(5)
FLMD0 TAUX4
(20)
wire
TRES
(4)
*2
*3*4
*5