To Next PageTo Next PageHow to fix a Dual DV927BT Car Receiver that won't turn on?
If your Dual Car Receiver won't turn on, it could be due to several reasons: * The yellow or red wire might not be connected properly or have incorrect voltage. Ensure these wires are correctly connected and have a voltage between 11 and 16VDC. * The black wire may not be connected to ground. Check this connection. * The fuse might be blown. If so, replace it with a new one.
Why does my Dual DV927BT Car Receiver keep blowing fuses?
If your Dual Car Receiver keeps blowing fuses, there are a few potential causes: * A yellow or red wire might be touching the chassis ground. Inspect these wires for any pinching. * Speaker wires could also be touching the chassis ground. Check them for pinching as well. * The fuse rating might be incorrect. Make sure you are using fuses with the correct rating.
What to do if my Dual DV927BT Car Receiver has power but no sound?
If your Dual Car Receiver has power but no sound, consider the following: * The speaker wires might not be connected properly. Check the connections at the speakers. * One or more speaker wires might be touching each other or the chassis ground. Insulate all bare speaker wires from each other and the chassis ground.
Why does my Dual DV927BT Car Receiver have audio but no video?
If your Dual Car Receiver has audio but no video, it might be because: * The parking brake safety circuit is not connected. Check the connections at the parking brake. * The parking brake is not applied. Apply the parking brake.
How to stop my Dual DV927BT from skipping?
Excessive skipping on your Dual Car Receiver can be caused by: * Incorrect mounting of the unit. Check the mounting sleeve. * Physical defects in the media. Inspect the disc for scratches.
Why is there no video display when reversing with my Dual DV927BT Car Receiver?
If there is no video display when your Dual Car Receiver is in reverse, it could be due to: * The reverse circuit not being connected. Check the connections at the reverse lamp. * The vehicle not actually being in reverse. Select reverse gear.
What to do if DVD does not start playback on my Dual DV927BT Car Receiver?
If your Dual Car Receiver DVD does not start playback, it may be due to: * Physical defects in the media. Check the disc for scratches. * Using the wrong region code. Use discs labeled "Region 1" or "All" only.
What does 'Disc Region Incorrect' mean on my Dual DV927BT?
If 'Disc Region Incorrect' appears on the display of your Dual Car Receiver, it means there is a region code error. Use discs labeled "Region 1" or "All" only.
General| Brand | Dual |
|---|---|
| Model | DV927BT |
| Category | Car Receiver |
| Language | English |
Key safety guidelines for operating the multimedia receiver.
Critical warnings about driver distraction and proper installation.
Regulatory compliance information regarding radio frequency interference.
Steps and considerations before installing the unit, including mounting.
Diagram detailing input/output connections for the unit's wiring harness.
Identifies the physical and on-screen controls of the multimedia receiver.
Instructions for inserting and replacing the battery in the remote control.
Covers basic functions, mode selection, setup menu access, and reset.
How to tune and operate the AM/FM radio functions.
Instructions for playing audio files from CDs and USB devices.
Details supported file formats and standards for CD, DVD, and USB media.
Guide to inserting, playing, and controlling DVD content.
Steps for pairing devices and using Bluetooth for phone and audio.
Instructions for connecting and playing music from an iPod device.
Using navigation, auxiliary inputs, and rear camera features.
Connecting steering wheel controls and using the Dual iPlug app.
Technical details and performance characteristics of the unit.
Details coverage, exclusions, and procedures for warranty service.
Common problems and solutions for unit operation.
General notes and additional information regarding the product.
