DUC Hélices FLASH-R - Shielding Leading Edge in Inconel; Accessories; Sales References

ISO 9001: 2015
TCDS EASA: EASA P.038
Part 21G EASA: FR.21G.0273
Certified FLASH-R
5/27
Shielding leading edge in Inconel
®
1.3.
The leading edge of the Certified FLASH-R blades is equipped with a metallic shielding in Inconel
®
. This material is a
superalloy containing mainly nickel, with a very high hardness of surface.
Accessories 1.4.
 Aluminum mounting spacer (Direct mounting on P.C.D Ø101.6mm/Ø4”)
Moves the plane of the propeller to adjust the position according the engine hood
 Aluminum adaptor spacer (Other mounting as SAE1, SAE2, …)
Move the propeller plane and adaptor the P.C.D fixation of the propeller
 Spinner available in diameter Ø250mm (Ø9.8") to Ø340mm (Ø14.4”)
 Adjusting tool for the setting of the pitch angle of the blades
 Neoprene cover protection of the blade
 Cleaning treatment for composite propellers
Save money! A clean propeller is more efficient and decreases the fuel consumption.
Sales references 1.5.
Designation
Reference
Part number
Three-blade Inconel FLASH-R Right (ROTAX mounting)
01-40-001
H-FSH_3-D-R_I_RX_C
Three-blade Inconel FLASH-R Right (AN6 mounting)
01-40-011
H-FSH_3-D-R_I_AN6_C
Three-blade Inconel FLASH-R Right (AN8 mounting)
01-40-021
H-FSH_3-D-R_I_AN8_C
Note:
Specify the flight regulation aircraft (E.g.: Ultra-light, LSA…) and diameter when ordering (E.g.: ref. 01-21-001/1730).
Inconel shielding