Contents page:
Part 3: Service Instructions Cl. 579
Program Version 579A04
1. General
1.1 Necessary Program Setting ........................................ 5
2. Setting the Positioning Points ..................................... 7
3. Setting the Upper Dead Center ..................................... 8
4. Setting of the Upper Dead Center for the Sewing Drive ..................... 9
5. Setting the Needle Bar Parallel to the Looper Turret ....................... 11
6. Alignment of the Looper Turret to the Cloth Support Plate ................... 12
7. Lateral Movement of the Cloth Support Plate ............................ 13
8. Lengthwise Movement of the Cloth Support Plate ......................... 14
9. Clamping Plates
9.1 Parallelism .................................................. 15
9.2 Clearance of the Clamping Plates to the Cloth Support Plate .................... 15
9.3 Setting the Spread.............................................. 16
10. Height of the Cloth Clamps ....................................... 17
11. Setting of the Cloth Clamp Pressure ................................. 18
12. Setting the Seam Width
12.1 Narrow Seam Width ............................................. 19
12.2 Wide Seam Width .............................................. 20
12.3 Needle-Zero Setting............................................. 21
13. Cutting Knife
13.1 Position of the Cutting Knife ........................................ 22
13.2 Dressing of the Cutting Blocks ...................................... 24
13.3 Cutting Block Setting ............................................ 25
13.4 Cutting Pressure ............................................... 25
14. Looper Height ............................................... 26
15. Setting the Looping Stroke ....................................... 27
16. Needle Bar Height ............................................. 28
3
To Next Page
Need help?
General
