Contents page:
Preface and general safety instructions
Part 1: Operating instructions class 579
Program version 579A04
1. Product description
1.1 Designated use ..................................................5
1.2 Brief description..................................................5
1.3 Subclasses.....................................................7
1.4 Product structure .................................................8
2. Technical data ..................................................9
3. Operation
3.1 Needles, yarns and gimps ...........................................10
3.2 Removing and replacing the clamp plates..................................11
3.3 Changing the needle ..............................................12
3.4 Threading the upper thread ..........................................13
3.5 Threading the bobbin thread..........................................14
3.6 Threading the gimp thread (versions 579-121000, 579-141000 and 579-151000 only) .......15
4. Thread tensions
4.1 Needle- and bobbin-thread tension......................................16
4.2 Bobbin-thread-tensioning spring .......................................17
5. Changing the cutting blocks ........................................18
6. Spreading the workpiece...........................................19
7. Hand switches .................................................19
8. Switching on - Switching off - Firm hold
8.1 Switching on ...................................................20
8.2 Switching off ...................................................20
8.3 Firm hold .....................................................20
8.4 Switching threading mode on and off.....................................21
9. Controller
9.1 General ......................................................21
9.2 Operating the controller ............................................22
9.3 Changing parameter values ..........................................23
9.3.1 Numerical values ................................................23
1
To Next Page
Need help?
General
