Duerkopp Adler 579 - Page 2

Contents page:
9.3.2 Selecting a parameter .............................................23
9.4 Sewing process .................................................24
9.4.1 Switching on ...................................................24
9.4.2 Sequence mode and single-button mode ..................................24
9.4.2.1 Selecting a sequence (sequence mode)...................................24
9.4.2.2 Selecting a buttonhole (single-button mode) ................................24
9.4.3 Changing buttonhole parameters .......................................25
9.4.4 Automatic or manual operation (can only be set in sequence mode) ..................25
9.5 Sewing ......................................................26
9.5.1 Fast switch-off ..................................................26
9.6 Changing a buttonhole program........................................28
9.7 Buttonhole sequence ..............................................31
9.7.1 Selecting a buttonhole sequence .......................................31
9.7.2 Changing the buttonhole sequence......................................31
9.8 Piece counter ..................................................32
9.9 Buttonhole and sequence programming: a brief description ......................33
9.9.1 Selecting a buttonhole number ........................................33
9.9.2 Entering parameters ..............................................33
9.10 Setting buttonhole sequences: a brief description .............................34
9.10.1 Selecting a buttonhole sequence .......................................34
9.10.2 Changing a sequence..............................................34
10. Error messages
10.1 Pressure monitor ................................................35
10.2 Firm hold .....................................................35
10.3 Error messages .................................................35
10.4 Needle not in starting position.........................................35
10.5 Handwheel turned manually .........................................35
10.6 Sewing-start side not correct .........................................35
11. Maintenance
11.1 cleaning ......................................................36
11.2 Lubrication ....................................................37