14
Transport
1 Raise the drill into the transport position and hold at the full
extent of the rams for a few seconds to allow cylinders to
equalise.
2
Important - To avoid machine damage due to drill
lowering during transport, always close the hydraulic
valve at the quick release coupling. Move the handle to a
position at 90
0
to the hydraulic line
3
Maximum towing speed 40 km/hr.
For countries other than New Zealand greater speed
restrictions may apply, please refer to your local
transport authority.
Ensure towing vehicle requirements are adequate
for the towed vehicle e.g. mass, brakes. Refer to
recommendations published by the local Land Transport
Authority or equivalent.
Braking when towing can cause the load to jackknife. Use
extra care when towing in adverse conditions such as mud,
inclines and sharp bends.
Lower towing speeds are recommmended on farm roads/
tracks and where one wheel is on or over a road verge.
To Next Page
Loading...