73 … 96
72 … 96
Printed in Germany • Edition 04.18 • Nr. 271 958
Probus input data MPA to master
Input data is information about the
state of the MPA. The input data
contain a dierent number of bytes,
depending on the data transfer module
used. The lower bytes are always the
same, i.e. Basic transfer is included in
Standard transfer, Standard transfer in
Extended transfer.
Basic transfer 2 bytes
EB0 and EB1
Standard transfer 4 bytes
EB0 to EB3
Extended transfer 12 bytes
EB0 to EB11
Special Extended transfer 20 bytes
EB0 to EB19
The bytes EB0 and EB1 contain bit
information.
If the bit is set to 1, the condition is
included in the description of the bits.
Some bits are active during the fault
(marked with "X"), others are 0.
To Next Page
Loading...
Need help?
General