52 / 125
0006081263_200705
Display functions
Gas, pneumatic modulation
Operating mode
Information mode
Service mode
Parameterisation mode is password-protected.
System error messages
Error messages
Setup mode
Display functions
Parameterisation mode
Error indication
Display during standby
The automatic burner-control system is on standby follo-
wing a controlled shut-down. No pending request for heat.
The automatic burner-control system is on standby because
line voltage is too low.
The automatic burner-control system is on standby because
the safety circuit is interrupted.
The automatic burner-control system is on standby because
the signal for start prevention is applied via the eBUS.
To Next Page
Loading...
